Bumper & Door Guards Installation
The bumper must be clean and dry and should be intensively before fitting. If a car polish or care product has already been applied then the surface should be additionally cleaned with some cleaning alcohol or silicon remover, otherwise the self adhesive foil will not sick sufficiently. During the assembly, the environment temperature should not be below 59 F (15 C). For low temperatures, the surface and self-adhesive foil can be pre-warmed using a hairdryer in order to strengthen the self-adhesive process. Then the protective foil is removed, the bumper protector is placed on the bumper and pressed firmly using both hands. The self-adhesive foil requires a little time to optimally develope its sticking power. Therefore, you should wait at least 24 hours before cleaning your car in the carwash. The bumper protectors can be removed at any time. Adhesive remnants can be easily removed / rubbed of by hand with the aid of a hairdryer if nessassery.
- Some sets of Door Guards (Door Edge Guards) include the double-sideself-adhesive strips, protected by the masking tape. Remove the masking tape and place the strips along the edge of the door. Then attach the moulding to the strips.
- In some cases (D-64, 66, 67 - Door Guards), attach one side of the strips to the Door Guards and then install it by pressing it to the surface of the door.
- For glue set, avoid oil and water for 24 hours.
* Recently painted bumper should be completely dry before the installation. |
